What Is A Crystal? And How To Test It

ChicagoAnimation's top of the line services:

Web Site Promotion - We Guarantee you #1 listing in Yahoo and Google.

Flash Template customize service - We invented a way for small business owners to be able to afford a high end Flash site.

Pay Per Click management service - We help your small business to manage and bid on valuable keywords that can help produce profits for your business.

Press Release service - We help you launch your press release to news sources (reporters) through out the United States and all over the world.

Free Internet Marketing consultings from ChicagoAnimation.
To use this free service please fill out the form below and we will call you to offer you free tips.

* First Name:

* Last Name:

* Email Address:

* Phone Number:

Street Address:

City:

ZipCode:

Your State (2 Letters):

URL (if available):

Your Cell Phone #:

Company Name:

How long has your website been live?

What services or packages can we help you with?
SERVICES: Check all that apply.

	Search Engine Optimization
	Customize a Flash Template
	Customer Relations

	Site Building/Hosting
	eCommerce/Payment
	Other

PACKAGES: Check all that apply.

	Traffic
	Guarantee Prospects

	Communication
	Getting Started

How may we help you?
My current budget is. . .

Crystal are use to keep the frequency of the clock from drifting. If the signal from this clock stops, or is weak, or the pulses begin to vary, the electronic equipments might show intermittent faults or might stop altogether. The microprocessor pins that hold the crystal are usually called OSC IN and OSC OUT as shown in Figure 1 and the frequency is marked on the crystal. Typical examples of crystal oscillator frequency are 3.58MHZ, 4MHZ, 8MHZ, 24MHZ etc.

Testing Crystal
Crystals are quite fragile components because of their construction. Unlike a resistor or capacitor, if you drop one on the ground from a decent height, its 50-50 bet whether it will work again. Testing the crystal is not a breeze either. You cannot just take out your trusty multimeter and plug the crystal in it. In fact, there are three right ways to test a crystal: -

(a) Using Oscilloscope
A crystal produces a sine wave when excited. It is appropriate then, to see a waveform representative of a sine wave on the clock pins. If the clock is not functioning properly, replace the crystal. In most cases this should solve the problem since microprocessors are usually very reliable. Check the crystal with power on.

(b) Frequency Counter
Frequency Counter can be use to check the frequency of the crystal. The reading must be taken when the equipment power is switch "on". Place the probe of frequency counter to the crystal pin and read the measurement. Be sure that your frequency counter meter has the range that is higher than the crystal frequency you are measuring.

(c) Crystal Checker
With this method, usually the crystal is placed in the feedback network of a transistor oscillator. If it oscillates and the LED is lighten up, this mean that the crystal is working. If the crystal doesn't work, the LED stays off. Instead of using LED, some other crystal checker uses a panel meter to indicate if the crystal is working or not.

Jestine Yong is a electronic repairer and writer. For more information about electronic repair please visit his website at http://www.noahtec.com

MORE RESOURCES: